Loading... Please wait...

Company Info

Protech Composites Inc.
11700 NE 60th Way, Suite 3B
Vancouver, WA 98682-0808

Phone: +1 (360) 573 7800
Skype: protech.composites

Office hours:
Monday-Friday 8:00am-5:00pm PST

Introduction to Carbon Fiber

Download our free white paper for information on carbon fiber

Adhesive Options

adhesive450-300.png

Adhesive Backing

Our adhesive of choice is a high performance, high temperature film made by 3M. Rated at 400 degrees Fahrenheit, this adhesive will easily withstand the heat demands of most applications.

We like this adhesive for its clean, easy application. It comes with a two-sided paper backing – just peel off one side of paper backing and apply it to your carbon fiber. Peel off the second side and apply it to your application. Done.

If you order a sheet with adhesive, we’ll send you enough to cover your entire carbon fiber panel. The adhesive will be shipped to you unattached with instructions so you can cut and form the sheet and adhesive to your liking.

Other Adhesive Alternatives

Some customers prefer to use other adhesives for reasons including pricing, convenience and application requirements. In those cases, we recommend the following alternatives:

- contact cement
- water-based epoxy resin
- any standard laminate countertop adhesive

It's important to be sure the adhesive substance has dried thoroughly before applying the carbon fiber to your application. Trapped moisture will react with the resin and cause the carbon fiber to bubble over time.

 

Applying Adhesive

When a customer orders carbon fiber with adhesive, we provide them a two-sided sheet of adhesive to apply as they wish. One of the most common questions we get from customers is “how do I apply the adhesive to my carbon fiber sheet?”

Our adhesive of choice is a clear two-sided high temperature vinyl adhesive made by 3M.  We like it because there’s no mess, it’s easy to work with and it creates an extremely strong bond.  However, there ARE a couple tricks to working with it.

Here’s how we like to apply adhesive:

  • First, pull the protective paper off the back (non-printed) side of the adhesive sheet.
  • Lay the sticky side down onto the back side of the carbon fiber sheet and press into place.  Apply it carefully – the adhesive is very strong and you won’t have a chance to try again.
  • Gently heat the adhesive sheet with a hair dryer, hot gun, or place in the oven on low heat until warm (or approximately 100oF).
  • When warm, firmly press the adhesive onto the carbon fiber.  Carefully peel off the remaining paper.  If the adhesive starts to pull from the surface, lay the paper back down and apply more pressure. When you pull the paper up, there should be no bubbles or separation.
  • Apply the carbon fiber to the desired surface and press into place.

That’s it! Pretty simple. The heat’s the real secret to creating the best possible bond. Just be careful not to overheat.

Have a project in mind?

We're happy to provide a free, no obligation consultation.

 

grey-brand-logos.jpg